openmic.social is an uncensored community. You may encounter strong language, controversial opinions, and mature or NSFW material. You must be 18+ to browse. Illegal content is prohibited and removed on sight — please report it. By continuing, you accept that you may see content you personally disagree with.
You can buy a controller at any place that sells motors or Arduinos. None of my printers have their stock controller.
The firmware most controllers run is often a modified version of one of the different open source 3d printer firmwares (klipper, Marlin, etc)
You can even choose to compile and flash the firmware yourself (often just load bin file to sdcard and insert into board)
But all of that is moot because the controller and firmware are not capable of that level of processing. You would have to implement it on the slicer level, and even that wouldn’t work because most of them are open source.
You can buy a controller at any place that sells motors or Arduinos. None of my printers have their stock controller.
The firmware most controllers run is often a modified version of one of the different open source 3d printer firmwares (klipper, Marlin, etc)
You can even choose to compile and flash the firmware yourself (often just load bin file to sdcard and insert into board)
But all of that is moot because the controller and firmware are not capable of that level of processing. You would have to implement it on the slicer level, and even that wouldn’t work because most of them are open source.